We started with a meeting to review the current test procedures, set goals and expectations, and finalize the agenda. Once the agenda was set, our focus shifted to the floor where the test station would be setup. Prior to our arrival, the group had already unpacked the hardware and had been self-learning the MEDTEST system. They also made themselves familiar with Autoware® 3 software. Next, we looked at the Ultrasound machines (DUTs) which would be tested with the MedTEST system. Their DUT was a Class 1 device with 3 Patient Leads (F & CF type), and one enclosure point. The next few hours were spent carefully wiring up the test system and explaining the function of all test connections. This was followed by programming the test routines in Autoware 3 software based on the customer test requirements. Toward the end of day one we were able to test some samples of ultrasound machines to compare the test data with expected results.